FRIGIDAIRE FFGF3011LW - Manual (Page 16)

16
CARE & CLEANING
Replacing oven light (some models)
The interior oven light bulb is located at the upper left rear
of the oven cavity.
To replace the oven light bulb
1. Turn electrical power off at the main source or unplug
the range.
2. Replace bulb with a new 40 watt appliance bulb.
3. Turn power back on again at the main source (or plug
the appliance back in).
4. The clock will then need to be reset. To reset, see
“Setting the clock” in this Use & Care Guide.
Be sure the range is unplugged and all parts are COOL before
replacing oven light. Wear a leather-faced glove for protection
against possible broken glass.
CAUTION
Cleaning the cooktop and surface burners
(cont’d)
Removing and replacing surface burners
To remove burners
1. Remove shipping screws with a Phillips Head
screwdriver. See Fig. 1 for screw locations.
2. Tilt the burner at the end closest to the support bar
until the locator tab is released (front burners tilt right,
rear burners tilt left). Move the burner towards the
back of the range. This will separate it from the gas
valve at the front of the range.
To replace burners
1. Slide the burner tube over the gas valve at the front of
the range (front burners fit over the right valve, rear
burners fit over the left valve on each side of the
range).
2. Tilt burner so that the locating tab will slide into the slot
on the support bar. Make sure burners are properly
seated on support bar and are level.
3. Replace shipping screws.
To clean the surface burner heads
For proper gas flow it may be necessary to clean the burner
ports. Before cleaning be sure the gas burners are turned off.
First use a clean DAMP cloth to soak up any spills. Remove any
food from the burner ports using a small nonabrasive brush
like a toothbrush and afterwards wipe up using a damp cloth.
For stubborn soils located in the burner ports, use a small
gauge wire or needle to clean.
Any spill on or around the electrode must be carefully
cleaned. Take care not to hit the electrode with any thing
hard or it could be damaged.
Fig. 1
burner
support bar
shipping
screws
gas
valves
locating
tab
locating
tab
front burners
rear burners