Installation, Leveling, Cleaning – FRIGIDAIRE FFWC3822QS User Manual

Page 4: Handle installation, Location

Advertising
background image

4

nOtE

The exterior walls of the wine cooler may become quite

warm as the compressor works to transfer heat from

the inside. Temperatures as much as 30° F warmer

than room temperature can be expected. For this

reason it is particularly important in hotter climates to

allow enough space for air circulation around your wine

cooler.

Leveling

The wine cooler must have all bottom corners resting

firmly on solid floor. The floor must be strong enough

to support a fully loaded wine cooler. NOTE: It is Very

Important for your wine cooler to be level in order to

function properly. If the wine cooler is not leveled during

installation, the door may be misaligned and not close

or seal properly, causing cooling, frost, or moisture

problems.

To Level Your Wine Cooler:

After removing all interior and exterior packaging

materials, use a carpenter’s level to level the wine cooler

from front-to-back. Adjust the leveling legs in front, ½

bubble higher, so that the door closes easily when left
halfway open.

Cleaning

Wash any removable parts of the wine cooler interior,

and exterior with mild detergent and warm water.

Wipe dry. Do not use harsh cleaners on these

surfaces.
Do not use razor blades or other sharp instruments,

which can scratch the appliance surface when

removing adhesive labels. Any glue left from the tape

can be removed with a mixture of warm water and

mild detergent, or touch the residue with the sticky

side of tape already removed. Do not remove the

serial plate.

Important Safeguards: Do not store food in your wine

cooler as interior temperature may not get cool enough

to prevent spoilage. In summer months or areas of high

humidity, the glass door may build up moisture. To

remove the moisture, wipe it away.

Handle Installation

Set handle over the two mounting studs at top of

1.

door.
Use hex head screw driver or allen wrench to tighten

2.

set screws from bottom to secure handle to door.

� Handle

ĸ

Wooden Shelf Made of Beech

Ĺ

Control Panel

� Glass Door
� Control Switch of Lamp
� Adjustable Leg

Placement of Wine Cooler

The wine cooler should be placed in dry and ventilated room. The location of
the wine cooler should not be irradiated by direct sunshine. The wine cooler
should be far away from heating sources, such as: cooking stove or heating
radiator. If the wine cooler has to be placed near heating source, please adopt
proper heating insulation board for insulation or keep the wine cooler at least
the following minimum distances away from the heating sources:
For electric stove: 3 ΁.
For oil or coal stove: 30 ΁.

Replacement of Door Hinge

The door hinges of this wine cooler can be interchanged between the left and

right sides.

Installation of Handle

1. Set the handle on the fixation shaft.

Fixation Shaft of Handle

Set Handle

2. Screw down the fixation pins of the handle with screw driver.

- 7 -

Mounting stud

Locate handle

Screw driver

Handle Fixation Pin

Screw Driver

Level the Wine Cooler

Place the wine cooler on the planned location and level it.

The front screw of leg is adjustable.

Pay Attention to Room Temperature & Ventilation

The climate type is marked on the model nameplate. It indicates the room

temperature range for operation of wine cooler.

Climate Type

Indoor Temperature Range


N

+16°C to 32°C


ST

+18°C to 38°C


T

+18°C to 43°C



- 8 -

Set screw

InStALLAtIOn

This Use & Care Guide provides general operating

instructions for your model. Use the appliance only as

instructed in this Use & Care Guide. Before starting the

wine cooler, follow these important first steps.

Location

Choose a place that is near a grounded electrical

outlet. Do Not use an extension cord or an adapter

plug.

For optimal performance, it is recommended that

you install the wine cooler where the ambient

temperature is between 70 and 78 degrees

fahrenheit.

Allow space around the unit for good air circulation.

Leave a 2 inch space on the back and sides of the

wine cooler for adequate circulation.

Be sure the wine cooler stays in the upright position

during transport.

Keep the wine cooler from any hazardous or

combustible agents.

Advertising
This manual is related to the following products: