Acronis Backup for PC - User Guide - Manual (Page 104)

104 Copyright © Acronis International GmbH, 2002-2014
To specify credentials
1. Select one of the following:

Use the task credentials
The software will access the location using the credentials of the task account specified in the
Task parameters section.

Use the following credentials
The software will access the location using the credentials you specify. Use this option if the
task account does not have access permissions to the location. You might need to provide
special credentials for a network share or a storage node vault.
Specify:

User name. When entering the name of an Active Directory user account, be sure to also
specify the domain name (DOMAIN\Username or Username@domain).

Password. The password for the account.
2. Click OK.
According to the original FTP specification, credentials required for access to FTP servers are transferred
through a network as plaintext. This means that the user name and password can be intercepted by an
eavesdropper using a packet sniffer.
5.1.3 Access credentials for destination
To specify credentials
1. Select one of the following:

Use the task credentials
The program will access the destination using the credentials of the task account specified in
the Task parameters section.

Use the following credentials
The program will access the destination using the credentials you specify. Use this option if
the task account does not have access permissions to the destination.
Specify:

User name. When entering the name of an Active Directory user account, be sure to also
specify the domain name (DOMAIN\Username or Username@domain).

Password. The password for the account.
2. Click OK.
5.1.4 Where to recover
Specify the destination the selected data will be recovered to.
5.1.4.1 Selecting target disks
Available disk or volume destinations depend on the agents operating on the machine.
Recover to:
Physical machine
Available when the Acronis Backup Agent for Windows or Agent for Linux is installed.