Acronis Disk Director 11 Advanced Workstation - User Guide - Manual (Page 51)

51 Copyright © Acronis, Inc., 2000-2010

Use lower i-node density (that is, increased Bytes per i-node value) for a volume that
contains just a few large files. This will allocate more space for files and less for i-nodes. The
less i-nodes there are the in the system, the faster the “file system check” operation will be
performed.

Use higher i-node density (that is, reduced Bytes per i-node value) for volumes that contain a
large number of small files. This will allocate more space for i-nodes and less for data. The
more i-nodes there are in the file system, the less likely you will not run of i-nodes. But, the
“file system check” operation will be performed slower.
3. Click OK to add the pending i-node density changing operation.
The results of the pending operation are immediately displayed as if the operation had been
performed.
To perform the pending operation you will have to commit it (p. 23). Exiting the program without
committing the pending operations will effectively cancel them.