Acronis Disk Director 12 - User Guide - Manual (Page 35)

35 Copyright © Acronis International GmbH, 2002-2014
The change will affect only the Windows operating system whose disk layout is currently
selected—by default, the currently running Windows operating system. For information on how to
select the disk layout, see Disk layout (p. 21).
Caution: Avoid changing the drive letter of a boot volume. Otherwise, the corresponding Windows operating
system or some of the installed programs might fail to work normally.
To change a drive letter
1. Right-click the volume whose drive letter you want to change, and then click Change letter.
2. Select a new drive letter from the list of available ones. To leave the volume without a drive
letter, click Do not assign a letter.
3. Click OK to add the pending drive letter changing operation.
The results of the pending operation are immediately displayed as if the operation had been
performed.
To perform the pending operation you will have to commit it (p. 22). Exiting the program without
committing the pending operations will effectively cancel them.
5.11 Converting a primary volume to logical
This operation applies to basic disks whose partitioning scheme is MBR. It converts a primary volume
on such disk to a logical volume.
Each basic MBR disk can have either up to four primary volumes, or up to three primary volumes plus
an unlimited number of logical volumes.
You need to convert a primary volume to logical if you want to later create a fifth volume on a disk
that currently has four primary volumes.
The size of the converted volume might differ slightly from that of the original primary volume,
because some space might be required to store supplementary information.
Caution: Avoid converting the active volume or the system volume to logical. Otherwise, the machine will likely
become unbootable.
You can later convert the volume back to primary—see Convert to primary (p. 35).
To convert a primary volume to logical
1. Right-click the primary volume that you want to convert to logical, and then click Convert to
logical.
2. Click OK to add the pending primary volume to logical conversion operation.
The results of the pending operation are immediately displayed as if the operation had been
performed.
To perform the pending operation you will have to commit it (p. 22). Exiting the program without
committing the pending operations will effectively cancel them.
5.12 Converting a logical volume to primary
This operation applies to basic disks whose partitioning style is MBR. It converts a logical volume on
such disk to a primary volume.