FRIGIDAIRE FHPC3660LS - Manual (Page 2)

Accessories information available
on the web at frigidaire.com
Glass Canopy Island Hood
FHPC3660L S 36" Stainless Steel
USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca
FHPC3660L 02/12 © 2012 Electrolux Home Products, Inc.
Specifications
subject to change.
Glass Canopy Island Hood Specifications
• Product Shipping Weight (approx.) – 88 Lbs.
• Island / Peninsula Ceiling-Mount Installation
• Ventilation system is preset to exhaust air outside. If outside
ducting is not possible, optional Duct-Free Recirculation Kit
(PN # FHPRKT60LS) is available to convert ventilation to allow air
to recirculate inside. (Refer to Ducted Option Specifications for
outside ventilation.)
• Sones Rating – 6.5
• Voltage Rating – 120V / 60 Hz / 15 Amps
• Connected Load (kW Rating) @ 120 Volts = 0.52 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
• Amps @ 120 Volts = 4 Amps
• Always consult local and national electric codes. Check local building
codes for installation requirements, as they may vary per locale.
• Minimum installation height allowed from bottom of hood to standard
36"-high electric or gas cooking surface is 24" - 36". (NOT more than
32" recommended.) For detailed instructions regarding install heights
in 8', 9' and 10' ceiling applications, refer to installation guide on web.
• To prepare mounting surface, adequate structure and support must
be provided, capable of supporting 150 lbs.
Ducted Option Specifications
• For outside ventilation.
• Exhaust Duct Required – 6" round
• For most efficient airflow exhaust, use a straight run or as few
elbows as possible.
• Use metallic flex ducting only to connect rigid duct directly to
transitions (if allowed by code).
• Thermal breaks such as short section of nonmetallic duct, should
be used in areas of extreme cold.
• Cold weather installations should have additional backdraft damper
installed.
• Refer to installation instructions on web for detailed exhaust duct
preparation and converting vent blower system for recirculating inside.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Pre-Installation Calculations
• Select hood preference height (P) that is comfortable for user
(24" - 36" minimum allowed, NOT more than 32" recommended).
• Calculate hood height (H) for installation (H = K-C-P).
• Confirm that (H) is within minimum to maximum range for hood. If
not, adjust installation.
• Calculate chimney structure height (S). Use formulas, check
dimensions of hood. Save calculation for use later in installation.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Optional Accessories
• Duct-Free Recirculation Kit – (PN # FHPRKT60LS).
• 10' Flue Extension Kit – (PN # FHP10X60LS).
I/P Vent Hood
FHPC3660LS