FRIGIDAIRE FPEF4085KF - Manual (Page 15)

15
SETTING MAIN OVEN CONTROLS
MINIMUM AND MAXIMUM CONTROL PAD SETTINGS
All of the features listed below have minimum and maximum time or temperature settings that may be entered into the
control. An ENTRY acceptance beep will sound each time a control pad is touched (the acceptance beep on the Oven
Lockout pad is delayed 3 seconds).
An ENTRY ERROR tone (3 short beeps) will sound if the entry of the temperature or time is below the minimum or above
the maximum settings for the feature.
FEATURE MINIMUM TEMP. /TIME MAXIMUM TEMP. /TIME
BAKE 170°F/77°C 550°F/288°C
BROIL 400°F/205°C 550°F/288°C
CONVECTION BAKE 170°F/77°C 550°F/288°C
CONVECTION ROAST 170°F/77°C 550°F/288°C
TIMER 12 Hr. Mode 0:01 Min. 11:59 Hr./Min.
24 Hr. Mode 0:01 Min. 11:59 Hr./Min.
CLOCK TIME 12 Hr. Mode 1:00 Hr./Min. 12:59 Hr./Min.
24 Hr. Mode 0:00 Hr./Min. 23:59 Hr./Min.
DELAY START 12 Hr. Mode 1:00 Hr./Min. 12:59 Hr./Min.
24 Hr. Mode 0:00 Hr./Min. 23:59 Hr./Min.
COOK TIME 12 Hr. Mode 0:01 Min. 11:59 Hr./Min.
24 Hr. Mode 0:01 Min. 11:59 Hr./Min.
SELF CLEAN TIME 2 hours 4 hours
SETTING THE CLOCK
The SET CLOCK pad is used to set the clock. The clock
may be set for 12 or 24 hour time of day operation.
The clock has been preset at the factory for the 12 hour
operation. When the range is fi rst plugged in, or when
the power supply to the range has been interrupted, the
timer in the display will fl ash.
To set the clock (example below for 1:30)
1. Press SET CLOCK. “CLO” will appear in the display.
2. Press 1 3 0 pads to set the time of day to 1:30.
“CLO” will stay in the display.
3. Press START. “CLO” will disappear and the clock will
start.
CHANGING BETWEEN 12 OR 24 HOUR
TIME OF DAY DISPLAY
1. Press and hold SET CLOCK for 7 seconds.
2. After 7 seconds, “12h” or “24h” will appear in the
display and the control beep once.
3. Press SELF CLEAN to switch between the 12 and 24
hour time of day display. The display will show either
“12h” or “24h”.
4. Press START to accept the change or press CANCEL
to reject the change.
5. Reset the correct time as described in To set the
Clock above. Please note that if the 24 hour time
of day mode was chosen, the clock will now display
time from 0:00 through 23:59 hours.
SETTING CONTINUOUS BAKE OR 12
HOUR ENERGY SAVING
The TIMER and SELF CLEAN pads control the
Continuous Bake or 12 Hour Energy Saving features. The
oven control has a factory preset built-in 12 Hour Energy
Saving feature that will shut off the oven if the oven
control is left on for more than 11 hours and 59 minutes.
The oven can be programmed to override this feature for
Continuous Baking.
To set the control for Continuous Bake or 12 Hour
Energy Saving features
1. Press and hold TIMER for 7 seconds. After 7 seconds
“12h” or “- -h” will appear in the display and the
control will beep once.
2. Press SELF CLEAN to switch between the 12 Hour
Energy Saving and continuous bake features. Note:
“12h” in the display indicates the control is set for the
12 Hour Energy Saving mode and “- -h” indicates the
control is set for the Continuous Bake feature.
3. Press START to accept the change (display will
return to time of day) or press CANCEL to reject the
change.