FRIGIDAIRE FBD2400KQ - Manual (Page 3)

Specifications
subject to change.
Meets
requirements of
ASSE 1006
USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca
FBD2400K 03/14 © 2014 Electrolux Home Products, Inc.
Dishwashers
FBD2400K W/ B 24" Built-In
Dishwasher Specifications
• Product Shipping Weight (approx.) – 68 Lbs.
• Voltage Rating – 120V / 60 Hz / 15 Amps (maximum 20 Amps if
connected with disposer)
• Connected Load (kW Rating) @ 120 Volts = 1.44 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
• Amps @ 120V = 10 Amps
• Always consult local and national electric & plumbing codes.
Meets requirements of ASSE 1006 — integral air gap on supply.
• Water Pressure – Hot water line to dishwasher must provide
between 20 and 120 pounds per square inch (psi).
• Make sure location has right drain, water and electrical outlets
to make connections.
• Keep back free of drain, water & electrical supply.
• Electrical and water supplies should enter cabinet opening on floor,
or through back or side walls, as shown in shaded areas.
• Connections preferably located toward left side of dishwasher. Do not
cross drain, water or electrical lines in front of motor, blower or frame.
• When installing adjacent to wall, cabinet or other obstruction that
extends beyond front edge of unit, allow 2" minimum clearance
between opened door and obstruction.
• When installing at end of cabinet line, sides must be fully enclosed.
• Do not install unit under a cooktop, damage will occur.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
24" Built-In Dishwasher w/Mechanical Controls (MC)
Baseline (FBD2400K)