AAXA Technologies P4 Wi-Fi - Manual (Page 8)

Getting Started
1. Connect the power cord to the P4 Wi-Fi.
2. Connect the wall plug into the wall power source.
3. Press POWER button and hold for 2-3 seconds to switch on or switch off
the power
• The LED turns red while charging.
• The LED turns green when charging is finished.
• 4 hours of charge time is required to reach a full charge.
5
Powering ON the projector
Chapter 2
Powering OFF the projector
1. Press and hold the power button for 3 seconds.
2. The optical engine should power off and the fan should stop spinning.
• Note. Pressing the power button on the remote puts the projector in
standby mode. It will NOT turn off the projector.
Note: The P4 Wi-Fi Projector battery does not charge when it is in operation.