Casablanca Fan Company S3 - Manual (Page 7)

6 6
Step 4. To hang the fan body in the
canopy, hold the fan body firmly and in-
sert the ball into the canopy opening.
Check that no wires were pinched. Ro-
tate the fan body until the slot in the
nylon ball fits into the pin opposite the
canopy opening.
HANGING THE FAN
PIN SLOT
BALL
CANOPY ELECTRICAL CONNECTIONS
Step 5a. Attach the fan wires to the ceiling fixture outlet
box wiring by twisting the bare ends of the wires together
and then securing with a wire nut. Test that the connection
is secure by pulling on the wire nut. Connect in this order:
Step 5b. Wiring Connections
• GREEN leads from mounting plate and fan to GROUND con-
ductor of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling
fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to BLACK power wire in ceiling
outlet box. Secure with wire nut.
2 WHITE WIRES
2 BLACK WIRES
WIRE NUT
3 GREEN WIRES
CANOPY HATCH INSTALLATION
Step 6. Tuck the wires into the canopy
with the wire nuts pointed upwards, so
that the WHITE and BLACK wires are on
opposite sides of the canopy and all wires
are clear of the canopy opening.
Step 7. Install canopy hatch with the last
canopy screw and lock washer. To do this,
tilt the fan body away from the hatch
opening.
Tighten the screws firmly by hand only,
TILT THE
FAN TO
INSTALL
LAST
CANOPY
SCREW
CANOPY
HATCH
CANOPY
SCREW
LOCK
WASHER
Step 8. Straighten the fan, then check
to ensure that there is no movement be-
tween the canopy and ceiling or Hang-Tru
ball and top support shaft.
NOTE: The fan weight is 23 pounds.