Canon LV-7585 - Manual (Page 11)

11
Rear Terminal
G
R/C JACK
When using the wired remote control unit, connect
the wired remote control unit to this jack with a
remote control cable (not supplied).
 Note:
• Use a DVI-Digital cable which fits the width of the rear
terminal.
<
S-VIDEO INPUT JACK
Connect the S-VIDEO output signal from video
equipment to this jack (p.21).
B
MONITOR OUT TERMINAL
This terminal can be used to output the incoming
analog RGB signal from INPUT 1-3 terminal to the
other monitor (pp.20-21).
E
VIDEO INPUT JACK
Connect the component or the composite video
output signal from video equipment to this jack
(p.21).
H
CONTROL PORT CONNECTOR
When controlling the projector from a computer,
connect the computer to this connector with a
control cable (p.20).
D
COMPUTER INPUT TERMINAL (DIGITAL)
Connect the computer output digital signal to this
terminal. The HDTV (HDCP compatible) signal can
also be connected (pp.20-21).
J
COMPUTER INPUT TERMINAL (ANALOG)
Connect the computer (or RGB scart) output signal
to this terminal (pp.20-21).
8
5 BNC INPUT JACKS
Connect the component or composite video output
signal from video equipment to VIDEO/Y, Pb/Cb,
and Pr/Cr jacks or connect the computer output
signal (5 BNC Type [Green, Blue, Red, Horiz. Sync,
and Vert. Sync.]) to G, B, R, H/V, and V jacks (pp.20–
21).
D
J
8
E
G
L
<
H
B
=
;
; RESET button
A built-in micro processor which controls this unit may
occasionally malfunction and need to be reset. This can
be done by pressing the RESET button with a pen, which
will shut down and restart the unit. Do not use the RESET
function excessively.
=
This slot is for a Kensington lock used to deter theft of the
projector.
*Kensington is a registered trademark of ACCO Brands Corporation.


INFRARED REMOTE RECEIVER (Back)
The infrared remote receiver is also located in the
front (pp.10, 15).

Part Names and Functions
L
USB CONNECTOR (Series B)
Use this connector when controlling a computer
with the remote control unit of the projector.
Connect the USB terminal of your computer to this
connector with the supplied USB cable (p.20).