CLIFFORD Auto Security SuperNova - Manual (Page 13)

Feature
Factory
setting
# of
momentary
presses
Secondary
action
Program
completion
confirmation
Result
FACT —
False Alarm
Control and
Test
ON 12 —
1 chirp 3
seconds after
last tap
Change state from
OFF to ON or vice-versa
Add a New
Remote to
Channel 1
(arm/disarm)
— 13
Press remote control button 1
2 chirps
Button 1/channel 1 code
of the new remote control
has been memorized
Add a New
Remote to
Channel 2
(optional
remote
accessory)
— 14 Press remote control button 2 2 chirps
Button 2/channel 2 code
of the new remote control
has been memorized
Add a New
Remote to
Channel 3
(silent
arm/disarm)
— 15 Press remote control button 3 2 chirps
Button 3/channel 3 code of
the new remote control
has been memorized
Add a New
Remote to
Channel 4
(optional
remote
accessory)
— 16
Press remote control button 4
of the optional
4-button/12-channel
remote control
2 chirps
Button 4/channel 4 code
of the new remote control
has been memorized
Example
To change the AutoArming feature from its factory setting of “on” to “off,”
you would do the following:
Turn the ignition key to the ON position.
Enter your valet code, then immediately tap and release the
momentary side of the PlainView switch 4 times (you will hear a
single chirp upon the 4th press).
Wait 3 seconds. The system will sound one more chirp to confirm that
the AutoArming setting has been changed.
Turn the ignition off (you’ll hear 3 chirps to confirm exit of program
mode).
That’s all there is to it!
12