Cobra Electronics CP-2507 - Manual (Page 11)

SYSTEM
The revolutionary, patented Intenna hidden-antenna system is a Cobra exclusive.
Intenna is the worldÕs first and only full-range-power cordless telephone that con-
ceals the handset and base antennas inside the phone and out of the way. No more
antennas to extend, bend or break. CobraÕs hidden antennas are perfectly matched
to your phoneÕs microprocessor circuitry for optimum performance offering the
ultimate in user-friendly convenience.
LAST NUMBER REDIAL
Each time you dial, the phone number youÕre calling is automatically saved in
a special REDIAL memory. To call that number again at a busy signal, press
FLASH (without hanging up) to get a new dial tone, then press and release the
REDIAL button. If you wish to try the call in a few minutes, use TALK to access
the dial tone, then press and release the REDIAL button. The number will au-
tomatically be redialed.
MEMORY DIALING (STORAGE)
Your Cobra Intenna cordless phone enables you to store up to ten frequently
dialed phone numbers or emergency numbers. With the TALK indicator light
off, press and release the MEMORY button ; enter the digits of the phone num-
ber you wish to store, up to 16 digits; press and release the MEMORY button
again. Now assign your memory number a position by entering any keypad
number from 0 to 9. You will hear a confirmation beep. Repeat until all ten num-
bers are entered. NOTE: for automated banking or alternate long distance ser-
vice, you may need to program a number which is longer than 16 digits. You
will need to divide the number between two memory I.D. numbers. Follow the
steps above.
MEMORY + TELEPHONE + MEMORY + I.D. # = CONFIRMATION
NUMBER (0Ð9) TONE
MEMORY DIALING (RECALL)
To call a number stored in memory, press TALK to get a dial tone; press MEMO-
RY button. Press the keypad number you assigned to that number and your
phone will automatically dial the number. NOTE: for longer numbers which you
have stored in two different I.D. numbers, follow steps above, pressing MEMO-
RY button again before entering the second number. Use the memory sticker card
provided to write down the names of each memory position. Keep this in any
covenient place.
10
TALK + MEMORY + I.D.# = MEMORY
DIAL 0-9