Cobra Electronics MAGNETIC CM/200/3 - Manual (Page 3)

RLL233 Issue 4 Aug 2007
2
[1] ROTABROACH MAGNETIC DRILLING MACHINE
MODELS CM/200/1/ & CM/200/3
Maximum hole cutting capacity in .2/.3C steel = 65mm dia. x 50mm deep
Arbor bore = 19.05mm (3/4") dia.
Motor Unit
Voltages
110v 230v
normal full load 14 A 1400 W 6 A 1400 W
Electro Magnet 0.6A 69W 0.3A 69W
Size 180mm long
90mm wide
Tractive Force at 20°C with 25mm
minimum plate thickness
The use on any material less than 25mm thick will
progressively reduce the magnetic performance. If
possible, substitute material should be positioned under
the magnet and work piece to equate to a suitable
material thickness. If this is not possible, an alternative
secure method of restraining the machine MUST be
used.
1200kgs
Total Load (magnet + motor) 1469 W 1469 W
Overall Dimensions
Height - maximum extended
550mm
Height - minimum 470mm
Width (including Hand wheel) 200mm
Length Overall (including Guard) 270mm
Nett Weight 16kgs
Maximum hand/arm vibration magnitude (measured at
handle during operation in accordance with ISO5349,
using a 22mm cutter through 13mm MS plate)
0.82 m/s_
Estimate of likely daily vibration exposure. Operation
30 holes @ 2 minute/hole.
0.29m/s_ A(8)
Average noise level during cutting at operators ear
position.
89dB(A)
Ear defenders must be worn when operating this machine
These tools are UK designed, and manufactured with globally sourced components and
conform with the requirements of EEC Document HD.400.1 and BS.2769/84
Suitable only for a single phase 25-60Hz A.C. power supply
DO NOT USE ON D.C. SUPPLY
Do not use your magnetic drill on the same structure when arc welding is in progress.
D.C. current will earth back through the magnet and cause irreparable damage.
WARNING: THIS APPLIANCE MUST BE EARTHED!
NB: ANY MODIFICATIONS TO THIS MACHINE WILL INVALIDATE THE GUARANTEE