Chicago Electric 67089 - Manual (Page 9)

SKU 67089 For technical questions, please call 1-800-444-3353. Page 9
record product’s Serial number Here:
note: If product has no serial number, record month and year of purchase instead.
note: Some parts are listed and shown for illustration purposes only, and are not avail-
able individually as replacement parts.
troubleshooting
problem possible causes likely Solutions
Tool will not start. Battery not charged. Charge Battery.
Performance
decreases over
time.
Accessory dull or damaged. Keep accessories sharp. Replace as needed.
Excessive noise
or rattling.
Internal damage or wear. Have technician service tool.
Tool chatters
when tightening
fasteners
Low Torque setting. Select higher Torque setting.
Overheating. Forcing tool to work too 1.
fast.
Accessory dull or
2.
damaged.
Blocked motor housing 3.
vents.
Allow tool to work at its own rate. 1.
Keep cutting accessories sharp. Replace 2.
as needed.
Wear ANSI-approved safety goggles and
3.
NIOSH-approved dust mask/respirator while
blowing dust out of motor using compressed
air.
Follow all safety precautions whenever diagnosing or servicing the
tool. disconnect power supply before service.