Char-Broil COMMERCIAL 463268008 - Manual (Page 20)

12
11 Under sideburner shelf, attach sideburner ignitor wire to electrode
(A). Place burner cap onto sideburner. Attach sideburner
cap clip
(B). Place sideburner grate onto sideburner shelf, aligning grate legs with holes in shelf.
Burner cap
Sideburner grate
Sideburner Ignitor Wire
A
B
Sideburner
cap clip
First, attach tank heat shield and shield extension together with two
#8-32x3/8” screws, 4mm flat washers, 4mm lock
washers and #8-32 hex nuts. Inside of cart, insert rear shield tabs into two left slots between upper and lower back panels.
Attach left and center front shield tabs under front brace with
#8x3/8” self-tapping screws. Insert left and right grease tray
rails into slots beneath grease tray opening in upper back panel. Attach left rail to brace, with a
#8x3/8” self-tapping screw.
Attach right rail and right front shield extension tab together under front brace with a
#8x3/8” self-tapping screw.
Some components not shown for
illustration purposes.
Tank heat shield
Tank heat shield extension
Grease tray opening
#8-32x3/8”
Screw
#8-32 Hex nut
4mm Lock washer
4mm Flat washer
Left grease tray rail
Right grease tray rail
#8x3/8” self-
tapping screw
Front brace
Rear of shield - two tabs.
20 • 463268008