Chicago Electric MIG 180 Wire Feed Welder 68886 - Manual (Page 9)

Page 9 For technical questions, please call 1-800-444-3353. SKU 68886
Wire Spool Installation
1. Turn the welder OFF and unplug
it before proceeding.
2. Pull up on the door latch,
then open the Door.
3. Remove the Spool Knob, Spool Spring, and upper
Spool Plate. If replacing a Spool, remove the old
Spool and all remaining wire from the liners.
4. Place the new Wire Spool over the Spool Spindle
and on top of the lower Spool Plate as illustrated.
To prevent wire feed problems, set the
Spool so that it will unwind clockwise.
5. Secure Spool in place with the upper Spool Plate
(narrower end against the Spool),
then the Spool Spring and Spool Knob.
MIG 180
WIRE FEED WELDER
ITEM 68886
WIRE FEED SPEED
240V~
I
O
door
latch
Door
Spool Knob
Wire Spool
Lower
Spool Plate
Upper
Spool Plate
Spool Spring
Spool Spindle
wire must
unwind this
direction
SAFETY
MAINTENANCE
BASIC WELDING
WELDING TIPS
SETUP