Dell PowerVault 50F (Fibre Channel Switch) - Manual (Page 17)

Rack Installation Guide 1-1
  
    




  !
This document provides instructions for trained service technicians installing one or
more Dell PowerVault 51F Fibre Channel switches in a Dell rack. The switch rack-
mounting hardware includes the following items (see Figure 1-1):

One switch assembly, consisting of a manifold with an attached bezel, two inner-
slide rails, and the switch

One slide assembly, consisting of two outer slides, each with a stationary and an
adjustable bracket, and two intermediate slides

One cable-management arm

Eight 10-32 x 1/2-inch screws

Eight tapered washers
The following sections describe the tasks required to install the PowerVault 51F
switch in a Dell rack.
" "
Before you install your PowerVault 51F switch in the rack, read the safety information
at the front of this guide and the tool requirement in the following subsection.



To install the PowerVault 51F switch, use a #2 Phillips-head screwdriver and a flathead
screwdriver.
4939tbk1.book Page 1 Friday, October 8, 1999 1:22 PM