Carrier DEBONAIR 33CS User Manual

Owner’s manual, Debonair™ 33cs commercial programmable thermostat, Part number 33cssp2-wc

Advertising
background image

Owner’s Manual

Part Number 33CSSP2-WC

IMPORTANT: Read entire instructions before program-
ming the thermostat.

GENERAL

The commercial, programmable thermostats are wall-

mounted, low-voltage thermostats which maintain room tem-
perature by controlling the operation of an HVAC (heating,
cooling and ventilation) system. Separate heating and cool-
ing set points and auto-changeover capability allow occu-
pied and unoccupied programming schedules for energy savings.

All thermostats allow up to 3 occupied and one unoccu-

pied time/temperature setting to be programmed per 24-hr
period. Each thermostat stores programs for 3 different days
(Saturday, Sunday, and Monday through Friday). Batteries
are not required. During power interruption the internal
NEVERLOST™ memory stores programs for an unlimited
time.

CONFIGURATION

Thermostat Display —

The thermostat display is lo-

cated in the center of the thermostat. See Fig. 1. The fol-
lowing information can be displayed on the screen:
• mode (OFF, HEAT, COOL, AUTO, or PROGRAM ON)
• fan setting (FAN ON or blank)
• override indication
• room temperature
• desired temperature
• time of day
• day of the week
• schedule period (Occupied 1, 2, or 3; or Unoccupied)
• setup indicator (programming mode)
• lock indicator
• start/stop indicator (schedule period program mode)

Heat or Cool Indicator —

A Heat or Cool indicator is

located on the bottom middle cover of the thermostat. See
Fig. 2. The light will be red if the thermostat is in Heating
mode. The light will be green if the thermostat is in Cooling
mode.

Thermostat Front Panel Buttons —

The thermo-

stat has buttons on the front cover which are used to raise or
lower the desired set point and override the current program.
See Fig. 2.

SET POINT BUTTONS — The UP ARROW and DOWN
ARROW buttons will raise or lower the current desired tem-
perature set point. If the thermostat is in AUTO mode, press-
ing the UP ARROW or DOWN ARROW button will adjust
both the heating and cooling set points. Pressing the UPAR-
ROW or DOWN ARROW button in Cooling mode will ad-
just only the cooling set points. Pressing the UP ARROW or

DOWN ARROW button in Heating mode will adjust only
the heating set points. The UP ARROW and DOWN AR-
ROW buttons are also used in Programming mode.

OVERRIDE BUTTON — The Override button is used to
force the thermostat from Unoccupied mode into the Occu-
pied 1 mode comfort settings. The Override period will be
set at 30 minutes. The thermostat will then return to Unoc-
cupied mode. To increase the amount of time in Override
mode, press the Override button again. Thirty minutes of over-
ride time will be added for each time the Override button is
pressed up to a maximum of 4 hours. After the 4-hour limit
has been reached, press the Override button again to cancel
Override mode.

Fig. 1 — Thermostat Display

Am

COOL

HEAT

AUTO

DISPLAY
SCREEN

MODE
BUTTON

OVERRIDE
BUTTON

INDICATOR
LIGHT

DOWN
ARROW
BUTTON

UP
ARROW
BUTTON

Mo

Fig. 2 — Thermostat Front Cover

Debonair™

33CS

Commercial

Programmable Thermostat

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.

Book 1

4

Tab

11a 13a

PC 111

Catalog No. 533-347

Printed in U.S.A.

Form 33CS-11SO

Pg 1

2-99

Replaces: New

Advertising