Casio PS-3000 - Manual (Page 30)

E-28
Assembly Instructions
417A-E-030B
Perform the following steps.
Figure 4
1. Attach side panel A to the piano. Secure the side panel in
place using two screws D (Figure 4).
• Be sure to tighten the screws securely.
2. Attach side panel B to the other side of the piano. Secure
the side panel in place using two screws D (Figure 4).
• In this case, do not tighten the screws all the way. If you
do, you will not be able to insert the speaker box C in
the following steps.
3. Attach speaker box C to side panels A and B.
• Secure the speaker box in place using four screws D
(Figure 4).
4. Lift up the speaker box C so its screw holes align with the
screw holes in the side panels, and then tighten the screws
D.
5. Partially tighten the screws on one side of the speaker box
C and then tighten the screws on the other side completely.
6. Fully tighten the two screws you partially tightened in step
2, above.
7. Next, fully tighten the screws that you partially tightened
on one side of the speaker box.
Figure 5
8. After ensuring that all of the screws are fully tightened,
remove the packing material and stand up the piano (Figure
5).
• Two people, one at either end, should hold the front and
back of the piano when standing it up.
• Connect the cable to the speaker connector (
★
in Figure
5).
• Install the screw caps E on each of the eight screws
(Figure 4, 5) .
A B
D D
C
E E
★
E
Figure 6
F Cable clip
9. Attach the cable clip F to the bottom of the piano (Figure
6).
• Use the cable clip to bundle the adapter and pedal cables
together.
• See “Power Supply” on page E-10 for information about
using the cable clip.
PS3000_e_26_31.p65 03.10.8, 2:22 PM 28