Vermont Casting SNV30 - Manual (Page 8)

8 8
Stardance Natural Vent Gas Heater
20007067
ST640
RUVSOD
snapstat
7/01
Snapstat Bracket
Snapstat Module
Pinch
Grommet to
Remove
ST670
Fig. 9 Remove the snapstat and grommet from the bracket
4. Connect snapstat leads. Disconnect the snapstat
module from the leads inside the snapstat bracket.
(Fig. 9) Bend open the snapstat bracket. Use needle
nose pliers to remove the black plastic grommet
from the bracket. Discard the bracket. Connect
the two wires to the two snapstat extension leads
located between the inner and outer shroud.
5. Position the fan assembly so the ducts slide be-
tween the inner and outer shroud. The inner shroud
should engage with the two slots in the ends of the
bracket so the bracket and shroud are interlocked.
(Fig. 10) Secure the bracket with the four sheet
metal screws provided in the finish bag.
6. Install the snapstat by loosening the front screw on
the inner side of the duct. (Fig. 11) Slide the snapstat
under the head of the screw and tighten. Connect
the leads to the snapstat. Make sure the snapstat
assembly is mounted straight front to back.
7. Reattach rear shroud assembly in reverse order of
Step 2. Tighten bottom bolts to hold shroud in place.
WARNING
This appliance is equipped with a three-prong
(grounded) plug for your protection against shock
hazard and should be plugged directly into a
properly grounded three-prong receptacle. Do not
cut or remove the grounding prong from this plug.
Install the Optional Fan
If you are installing the optional convection Fan Kit
#2767 (FK26), continue here. If you are not installing a
fan kit, proceed to Venting System Assembly.
1. The fan kit includes a blower assembly and a rheo-
stat assembly, connected by a cable. The blower as-
sembly mounts to the bottom rear of the stove, and
the rheostat mounts to the left side of the valve. The
assembly includes a ‘snapstat’ which automatically
turns the fan ON (or OFF) above (or below) approxi-
mately 109°F. The rheostat also provides a range
of fan speed settings from Off (which overrides the
snapstat function) to High. Unpack and inspect the
blower assembly. Confirm that the fan spins freely.
2. Remove the rear shroud by loosening the two (2)
bolts at the bottom left and right side of the shroud.
Slide shroud straight up, rotate the bottom out and
away from stove and pull shroud out.
3. Attach the fan assembly to the fan bracket provided
in the log box. Use #10 sheet metal screws provided
in fan kit. Do not remove finger guard screws. (Fig. 8)
Installation
Unpack the Stove
The Stardance is shipped fully assembled on its back.
Unpack the stove and carefully set it upright.
ST669
RUVSOD
attach fan to bracket
7/01
Snapstat
Wire
Rheostat Wire
Fan Bracket
Finger Guard
ST669
Fig. 8 Attach the fan assembly to the fan bracket.
CAUTION
Porcelain enamelled surfaces are fragile. Handle
porcelain enamelled castings tenderly. Familiarize
yourself with the assembly steps before you begin
and proceed with deliberation and care. If possible,
have assistance available.
Place enamelled castings on a soft, cushioned sur-
face until you are ready to assemble.
Avoid contact between the castings and other hard
surfaces or objects.