Remote led diagram and icons, General system functions, Sending commands – CompuSTAR Pro system User Manual
Page 7: Receiving commands
Remote LED Diagram and Icons
Remote LED Diagram and Icons
Your remote pager will indicate the status of your vehicle while in range through a series of flashing
LEDs. The unique LED design will visually display such icons as lock/unlock status, remote start
confirmation and all the icons to show your vehicle is running, impact/shock notification and much more.
Below is a chart that shows what LEDs will blink when certain commands are sent to and from the
CompuStar.
Your remote pager will indicate the status of your vehicle while in range through a series of flashing
LEDs. The unique LED design will visually display such icons as lock/unlock status, remote start
confirmation and all the icons to show your vehicle is running, impact/shock notification and much more.
Below is a chart that shows what LEDs will blink when certain commands are sent to and from the
CompuStar.
Button
0.5 sec
2.5 sec
LED Icon
Lock/Arm
Lock then Panic
Unlock/Disarm
Aux 1
Trunk Pop
Aux 2
Activates the Remote Start
Siren on/off
Option Programming Menu 1 –
Installers Only
Valet Mode (see page 5 for
details)
Shock Sensor on/off
Drive Lock
Option Programming Menu 2 –
Installers Only
Activates Passive Arming
Activates Timer Start
Activates built in Turbo timer
Query to activate Secure Aux
General System Functions
The remote transmitter functions have been predetermined and programmed from the factory. The four
button configuration allows for many functions to be performed through a series of tapping, holding and /
or multiple presses of buttons. Although CompuStar PRO remotes have numerous button functions and
capabilities, please keep in mind that the most common functions are performed in one simple step.
Sending Commands
When in range, and a command has been sent, the remote pager LEDs will illuminate and the remote
will beep. For example, to send a remote start command from the pager, hold down button
for 2.5
seconds. The backlight will illuminate and the remote will beep once to confirm the command has been
sent and that the remote is in range. Once the vehicle has successfully remote started, the remote will
receive a command indicating the vehicle is running.
Receiving Commands
The remote pager will receive commands indicating the status of the vehicle, confirmation of sending
commands and alarm notifications. For example, after sending the lock command, the pager will be
updated with the
icon to confirm the vehicle has been successfully locked/armed. To see if your
7