Coleman 9992-645 - Manual (Page 24)

Replacing the Electrode Module
Fig. 49
Fig. 50
Fig. 51
Care, Maintenance and Cleaning
(continued)
Steps For Replacing the Electrode Module:
1. Remove the cooking grates and the heat tents and set aside.
2. Using a 1/4” hex nut driver, remove the self-tapping screws holding
the front heat shield (Fig. 49 and 50). Set the front heat shield
aside.
4. To remove the electrode module, unscrew the igniter button and remove the
AA battery. Next, unscrew the plastic hex nut from the electrode module
(Fig. 52).
5. Reverse the procedure to install a new electrode module.
NOTE: It does not matter which ignition wire goes to which tab on the
electrode module.
Fig. 52
3. The electrode module is now visible. Remove the four wires that are
factory installed from the electrode module to the burner electrodes
(Fig. 51).
Wires
Electrode
Module
24