Casio KL-780 - Manual (Page 24)

E-23
• Tape Cutting
Remove the tape cartridge and check
to make sure the ink ribbon is not
broken. Next, take up any slack in the
ink ribbon and then reload the tape
cartridge.
Important!
• Before loading a tape cartridge into
the label printer, always make sure
you take up any slack in the ink
ribbon first.
• If the ink ribbon is broken, you
must change to another tape
cartridge.
Tape cartridge loaded
while the ink ribbon is
slack.
Ink ribbon is being fed from the tape outlet along with the tape.
Possible Causes Action Page
Cannot cut tape.
Possible Causes Action Page
Tape cutter blade is dull. Take the label printer to the dealer
from whom you purchased it to have
the tape cutter blade replaced.
E-8
—
Printed text is cut off by tape cut operation.
Possible Causes Action Page
Replace the tape cartridge with a new
one. Out of tape
E-8
• Using Labels
Error Messages/Display Messages
Label will not adhere to a surface.
Possible Causes Action Page
Peel the backing paper from the back
of the tape to expose the adhesive.
Labels do not adhere well to surfaces
that are rough, wet, oily, or dirty.
The backing paper is still
on the back of the tape.
Surface is unsuitable for
affixing a tape.
E-16
E-16
Message
¥ ERROR!
* This message
appears on the
screen for about
one second.
NO DATA!
* This message
appears on the
screen for about
one second.
OVERWRITE?
SET/ESC
Possible Causes
• The number carriage
returns you input causes
the label to exceed the
maximum number of lines
for the tape you are
using.
• You are attempting to
print a stamp while three
lines of text are input.
• You are attempting to
recall text from memory
when there is none
stored.
• You are attempting to
store text in memory
when it already containes
text.
Action
• Use wider tape or reduce
the number of lines.
6mm tape...1 line
9mm tape...1 line
12mm tape...Up to 2 lines
18mm tape...Up to 3 lines
• Reduce the number of
lines of text to two.
• Press SET to overwrite
the existing text with the
new text, or ESC to
cancel the store
operation.