CITIZEN CT-S4000L - Manual (Page 26)

— 23 —
When using “label paper” with CT-S4000L and CT-S4000DCL, refer to the following. Use
the following paper or the equivalent paper.
Paper type Product name
Recommended thermal label paper 150LA-1 from Ricoh,
GG40/P22/G6B from Ojitac, HD75 from Nippon Paper
Full cut
position
Paper feeding
direction
Printable area
CAUTION!
Pay attention to the following when using Auto Cutter. Otherwise, a cutter lock or a
cutter failure may occur.
■ Set the cut length of paper to 25 mm or more.
■ When using label paper, cut the gap between labels (liner sheet). Do not cut the label
paper (tack paper).
■ Adusting the paper sensor must be carried when the type of liner is changed.
Label paper cannot be used with the model supporting blackmark (CT-S4000M/CT-
S4000DCM).
Mark Item Dimensions
A Liner width 58 to 112
B Label width 54 to 108 + 0.5
C Left edge of label 2 + 0.5
D Print width 50 to 104
E Top margin 2 + 1
F Print length 21 to 296
G Bottom margin 2 + 1
H Cut position between labels 1/2 x (Size I)
I Gap between labels 4 to 30
J Label length 25 to 300
K Label pitch I+J
L Left margin 2 + 1
M Right margin 2 + 1
Unit: mm
_
_
_
0
-1
_
_
a) Label paper *L