Harbor Freight Tools Model 97511 - Manual (Page 5)

SKU 97511
93909 For Technical Questions, Please Call 1-800-444-3353 Page 5
UNPACKING
When unpacking, check to make sure all the parts shown on the Parts List on page
11 are included. If any parts are missing or broken, please call Harbor Freight Tools at
the number shown on the cover of this manual as soon as possible.
OPERATION
For best service incorporate an oiler, regulator, and inline filter, as shown above.
Hoses, couplers, oilers, regulators, and filters are all available at Harbor Freight Tools.
1. You will need to prepare a 1/4” air connector (sold separately) to connect to the air
inlet on the Nailer. First, wrap the 1/4” air connector (not included) with pipe thread
seal tape before connecting to a 3/8” ID Air Source Hose (not included). Connect
the Air Source Hose to the Air Plug (79).
Note: If you are not using an automatic oiler system, before operation, add a few drops
of Pneumatic Tool Oil to the airline connection. Add a few drops more after each
hour of continual use.
2. Set the air pressure on your compressor to 70 - 125 PSI. Do not exceed the maximum
air pressure of 125 PSI.
3. Check the air connection for leaks.
Note: The amount of air pressure effects how deep the nails will be driven. It is
suggested that you experiment on scrap material.
4. Check the air connection for leaks and disconnect the Nailer.
workplace. Carry the tool by the handle and avoid contact with the trigger.
Note: Performance of the compressor (if powered by line voltage) may vary depending
on variations in local line voltage. Extension cord usage may also affect tool
performance.
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It must
be understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.