Wall mounting instructions – Cobra Electronics CP-2505 User Manual

Page 8

Advertising
background image

Wall Mounting Instructions

The following steps enable installation on a new or existing telephone wall-
mounting plate or directly onto a wall.

(Your Cobra Intenna is designed to be

used with any AT & T, GTE, local phone company or other wall-mounting
plates that can be purchased from most local electronics stores.)
•

Run telephone cord through cord wrap channel on bottom of base. (As shown).

•

Plug modular phone connector into telephone wall jack.

•

Align mounting studs on the plate to the holes on the bottom of the
Intenna base; push base onto studs and slide down on the wall plate.

•

Attach the power adapter to the POWER connection (on the base of the
phone) and plug into a household AC power outlet.

•

To install directly on any wall, you’ll need to provide two screws and wall
anchors; follow these steps:

— Drill two holes 3

1

/

4

" apart and insert the wall anchors.

— Drive the screws into the anchors until the head of each screw is

protruding about 1/8" from the wall.

— Align the holes in the cordless base over the screw heads; push base

in and slide down on screws (see diagram #3).

— Plug modular phone connector into telephone wall jack; attach the

power adapter to the POWER connection (on the base of the phone)
and plug into to a household AC power outlet.

7

Mounting Studs

Modular Phone Jack

Diagram #2:

Installation on a

telephone wall-

mounting plate

Diagram #3:

Installation

directly on a wall

Modular Phone Jack

Screw Heads

2505.MANUAL.pm

11/7/97, 11:43 AM

8

Advertising