Casio XJ-A250V/XJ-A255V* - Manual (Page 15)

E-14
Getting Ready
Locate the projector on a desk, table, or stand that is firm and level. Make sure to allow sufficient space
around the sides and back of the projector for proper ventilation.
 The following illustrations show how the projector should be oriented for optimum projection relative
to the screen.
Important! Important! Important!
 The projector can be oriented at an angle so its lens is pointing up to 30 degrees upwards (+30°)
or 30 degrees downwards (–30°).
Note that orienting the projector at a greater angle will shorten light source unit life and cause
malfunction.
There is no limit on how much the projector can be angled horizontally (left and right).
 The projector’s auto keystone correction range is 0 to +30 degrees. If the surface you are
projecting onto is angled downwards from horizontal, use manual keystone correction (page
E-22) to correct the image.
 Turn on the “Option Settings 2  High Altitude” setting on the setup menu when using the
projector in a high altitude (1,500 to 3,000 meters (5,000 to 10,000 feet) above sea level) area
where air is thin. For details, see the User’s Guide on the CD-ROM that comes with the
projector.
NOTE
 The projector can be configured for projection from the back of a screen. For details, see the User’s
Guide on the CD-ROM that comes with the projector.
Setting Up the Projector
Viewed from Above
Viewed from the Side
(XJ-A130V/XJ-A135V/XJ-A140V/
XJ-A145V/XJ-A150V/XJ-A155V)
Viewed from the Side
(XJ-A230V/XJ-A235V/XJ-A240V/
XJ-A245V/XJ-A250V/XJ-A255V)
The center of the projector’s lens should be
aligned with the horizontal center of the screen.
Screen
Make sure the projector is
at a right angle to the
screen.
Screen
Position the projector so
the lens side is at the edge
of the table, etc.
Screen