Cobra Electronics MF 2500 - Manual (Page 10)

Nothing Comes Close to a Cobra ® 9
Mounting the Fish Finder
2.3.1 Installation
Picture showing actual example of the MF 2500 Fish Finder installation.
Fix the MF 2500 Fish Finder to the mounting location using the four screws
(holes diameter 4 mm), see previous picture.
Route the CHARTPLOTTER cable to the CobraMarine
TM chartplotter.
Mount the transducer according to the instructions provided with it.
Connect the POWER cable to the battery. Please be advised that the MF
2500 Fish Finder when not operating will remain in Stand-By mode.
2.3.2 Installing Optional Devices
See the External Connection diagram in Par. 2.5.
2.4 STATUS LED
There are seven different LED behaviors, representing seven different
diagnostic conditions. These are described below.
1. BOOTLOADER
LED Behavior: OFF
The MF 2500 Fish Finder is running in the bootloader, or is not
powered on at all.
2. STANDALONE DST, NO TRANSDUCER MODE
LED Behavior: ON, steady