Cuisinart CWC-900 - Manual (Page 2)

1
IMPORTANT
SAFEGUARDS
When using an electrical appliance, basic
precautions should always be followed to reduce
the risk of fire, electric shock, and personal injury,
including the following:
1. Use this appliance only as described in
this manual. Other uses not recommended
may cause fire, electric shock or personal
injury.
2. This product is intended for household and
commercial use.
3. To protect against electric shock, do not
immerse unit, plug or cord in water or spray
with liquids.
4. Close supervision is necessary when any
appliance is used by or near children.
5. Unplug from the outlet when not in use or
when moving from one location to another,
and before cleaning.
6. To disconnect the appliance, grip the plug
and pull it from the wall outlet. Never pull by
the cord.
7. Do not operate the appliance in the pres-
ence of explosive and/or flammable fumes.
8. Do not place the appliance or any of its
parts near an open flame, cooking or other
heating appliance.
9. Do not operate the appliance with a dam-
aged cord or plug, if the product malfunc-
tions, or if it is dropped or damaged in any
manner.
10. The use of attachments not recommended
by the manufacturer may be hazardous.
11. Place the unit on a dry level surface.
12. Do not operate if the housing is removed or
damaged.
13. A loose fit between the AC outlet (recepta-
cle) and plug may cause overheating and a
distortion of the plug. Contact a qualified
electrician to replace loose or worn outlet.
14. This appliance is designed to be freestand-
ing only, and should not be recessed or
built-in (fully recessed.)
15. Locate the unit away from direct sunlight
and sources of heat (stove, heater, radiator,
etc.). Direct sunlight will affect/alter the out-
side color of the appliance.
WARNING: To reduce the risk of fire,
electric shock or personal injury, unplug
or disconnect the appliance from the power
supply before servicing.
SAVE THESE
INSTRUCTIONS
FOR HOUSEHOLD
AND COMMERCIAL
USE
SPECIAL CORD SET
INSTRUCTIONS
For your protection, this unit is equipped
with a 3-conductor cordset that has a molded
3-prong grounding-type plug, and should be
used in combination with a properly connected
grounding-type outlet as shown in figure A.
If a grounding-type outlet is not available, an
adapter, shown
in Figure B, may be
obtained so that a
2-slot wall outlet can
be used with a 3-prong
plug. Referring to
Figure C, the adapter
must be grounded by
attaching its grounding
lug under the screw of
the outlet cover plate.
NOTE: Do not remove
the grounding prong.
CAUTION: Before
using an adapter, it
must be determined
that the outlet
cover plate screw
is properly grounded.
If in doubt, consult a
licensed electrician.
Never use an adapter
unless you are
sure it is properly
grounded.
Note: Use of an
adapter is not
permitted in Canada.