Cabletron Systems 2200 - Manual (Page 31)

Installation 3-1
3
Installation
This chapter provides the instructions required to install the 2E253-49R. A Phillips screwdriver is
required to install options into the device or install the device into a rack. Follow the order of the
sections listed below to correctly install the device.
• Unpacking the Device ( Section 3.1 )
• Installing Options ( Section 3.2 )
• Installing the Device (on a shelf or tabletop, or into a standard rack) ( Section 3.3 )
• Connecting to the Network ( Section 3.4 )
• Completing the Installation ( Section 3.5 )
Only qualified personnel should install the 2E253-49R.
NOTE
Read the Release Notes shipped with the device to check for any exceptions to the
supported features and operation documented in this guide.