Cub Cadet 2206 - Manual (Page 43)

43
C. MAINTENANCE
CLEANING AND BLADE CARE
WARNING
Before performing any maintenance, place the
PTO switch in the “OFF” position, engage the
brake pedal lock, turn the ignition key to the
“OFF” position and remove the key from the
switch to avoid accidental starting and injury.
WARNING
When servicing the mower deck, be careful not
to cut yourself on the sharpened blades.
Clean the underside of the mower deck at the end of
the mowing season or when buildup of cut material on
the underside is noticed. Also remove the belt covers
and remove any accumulated grass clippings.
The cutting blades must be kept sharp at all times.
NOTE
Sharpen the cutting edges of the blades evenly
so that the blades remain balanced and the
same angle of sharpness is maintained. If the
cutting edge of a blade has been sharpened to
within 5/8 inch of the wind wing radius (See
Figure 63), it is recommended that new blades
be installed. New blades are available at your
authorized dealer.
Figure 63
When removing the blades, use a 1-1/4 inch open end
wrench to hold the hex shaped hub of the pulley when
loosening the hex nut securing the blade. A block of
wood may be placed between the deck housing and
the cutting edge of the blade to assist in removal of the
hex nut securing the blade (Refer to Figure 64).
Figure 64
After replacing the blades, apply grease to the
exposed threads at the bottom of the spindle shafts to
prevent rust buildup.
When replacing the blades, be sure they are installed
so that the wind wings are pointing upward toward the
top of the deck housing. Tighten the nuts to 90 to 110
ft-lbs. (122 to 149 N·m).
NOTE
If the spindle pulley nuts are removed for any reason,
they should be retightened to 50 to 60 ft-lbs. (68 to 81
N·m) torque when replaced.
LUBRICATION
After every 10 hours of operation and/or before putting
the deck into winter storage, lubricate the spindle
assemblies and the spindle belt idler arm using 251H
EP grease or an equivalent No. 2 multipurpose lithium
grease. Excess grease will be expelled from the upper
spindle seals. Since the spindle pulley covers the top
spindle seal, the expelled grease cannot be seen.
When the spindle is fully greased, the expelled grease
will cause the top spindle seal to give off a muffled
crackling noise (Refer to Figure 65).
WIND
WING
5/8" FROM
RADIUS
HEX NUT
1-1/8" WRENCH WOOD BLOCK
IN POSITION