Using the stroller as an infant car seat carrier – Chicco 430 User Manual

Page 12

Advertising
background image

Page 1

The Big Caboose Stand-On Triple Instruction Manual

Figure 

Figure 

Figure 

• To use the stroller to carry an infant

car seat carrier, you must replace the

Child Tray with the Car Seat Carrier

Support.

• Remove the Child Tray by pressing

in on the lock tabs and pulling the

tray off the brackets. Store the tray

in a convenient place for later use.

• Line up the female fittings on the

Car Seat Carrier Support to the male

fittings on the front of the stroller

and push inward until the fittings

snap into place. See Figure 23. Pull

outward on both sides of the support

to be sure both are snapped securely

in place.

• Push the canopy to its most rearward

position.

• Adjust the seatback to its reclined

position.

• Remove the infant carrier from the

car seat base.

• Place the infant carrier onto the top

of the stroller in a REAR FACING

POSITION, locating the head end

of the carrier so that it rests on the

Car Seat Carrier Support and the

feet end of the carrier so that it rests

on the seatback, but NOT on top of

the edge of the seatback. See Figure

24.

• Insure that the head end of the infant

carrier is pushed down firmly INSIDE

the frame of the Car Seat Carrier

Support and that it is centered side

to side.

• Remove the carrier restraining

straps from the pouches on both

sides of the stroller. Buckle them in

place over the LOWEST part of the

carrier sides. Adjust the straps so

they are tight around the carrier but

AWAY from the child’s neck. Pull up

on the carrier to be sure it is held on

securely. See Figure 25.

• Always check frequently to be sure

that the restraining straps are tight

across the infant carrier but away

from the child’s neck.

• When you remove the infant carrier

from the stroller, always replace the

two restraining straps back into their

side pouches.

Using the Stroller as an

Infant Car Seat Carrier

The Big Caboose will accommodate

a car seat carrier in EACH of the front

seating locations. Follow the same

instructions for each seat if two car

seats are to be installed.

Advertising
This manual is related to the following products:

437, 431