Casio XJ-460 - Manual (Page 44)

44
Using the Setup Menu
■Input Settings J Signal Name Indicator
This sub-menu lets you specify whether or not the name of the currently selected input
source should be displayed in the projected image.
Input Source Specific Menu Items
Setting Explanations
On: Turns on display of the name of the currently selected input source in the
projected image.
Off: Turns off display of the input source name.
Setting Storage
A single setting is stored, which is applied to all input sources.
■Input Settings J Special Signal
When a computer is connected to the RGB input terminal, the projector automatically detects
the type of RGB signal being sent from the computer and projects the image. Some signals,
however, cannot be detected properly by the projector. When auto detection is not possible for
some reason, try using this setting for a computer signal with a resolution of SXGA (1280 ×
1024) or SXGA+ (1400 × 1050).
Input Source Specific Menu Items
Setting Explanations
1280 × 1024: Specifies an SXGA (1280 × 1024) resolution RGB signal.
1400 × 1050: Specifies an SXGA+ (1400 × 1050) resolution RGB signal.
Setting Storage
This setting is saved for the RGB input terminal only.
Input Source Available Items (Parentheses indicate defaults.)
RGB (On), Off
Component
S-VIDEO
VIDEO
No Signal
Input Source Available Items (Parentheses indicate defaults.)
RGB 1280 Ч 1024, (1400 Ч 1050)
Component None
S-VIDEO
VIDEO
No Signal * Only when the currently selected input source is RGB.