Craftsman 486.244122 - Manual (Page 8)

8
22. Align two front holes in Support Bracket with holes
in front of foot rest on right side of tractor frame.
Remove any bolts present in holes, but leave all
brackets in place. Attach the Support Bracket using
two 3/8" x 1-1/4" hex bolts and 3/8" Nylock nuts. If
bolts won't fit, use 3/8" x 1"
thread forming bolts
without the Nylock nuts. See figure 22.
17. Move attachment lift lever all the way forward and lock
in position. See figure 28 on page 10.
18. Assemble lift arm link over channel rod and insert pivot
shaft end (from R.H. side of tractor) into hole in L.H. lift
pivot plate. Secure lift arm link to channel rod with 1/8"
(large) hairpin cotter. See figure 19.
19. Assemble a frame bracket under the right hand foot
rest of the tractor using two 3/8" x 1-1/4" hex bolts, two
3/8" lock washers and four short spacers. Use two
spacers on each bolt, between the frame bracket
and the tractor frame. See figure 19.
CLEVIS PINS
3/8" x 3/4"
HAIRPIN
COTTER
(SMALL)
HAIRPIN
COTTER
(LARGE)
LIFT PIVOT PLATE
LIFT
ASSEMBLY
PIVOT SHAFT
FRAME
BRACKET
RIGHT HAND SIDE VIEW
FRONT
FIGURE 21