Changhong Electric TM150F7E - Manual (Page 13)

PAGE 11
1. Remove the LCD TV from the box and place it on a flat surface in a well-ventilated
location.
2. Connect the output terminal of RF cable to the corresponding TV RF signal input
terminal. The LCD TV is a high-tech digital product. Do use quality RF cable to obtain
optimal results.
3. Connect the output terminal of the AV devices such as YPbPr, DVD to the corresponding
terminal of the LCD TV.
4. Connect one end of the VGA terminal to the corresponding signal source terminal, and
connect the other end to the corresponding LCD TV terminal. Screw down the screws
on both sides to secure it.
5. Ensure that every AV signal cord is correctly connected to the corresponding interface.
6. Connect one end of the AC power cord to the AC input jack of the LCD TV, then plug the
other end to the corresponding jack.
7. The panel can be tilted upwards by no more than 10
0
to achieve better visual angle. When
doing so, so rotate the TV with two hands, one to fix the pedestal while the other to tilt the
panel. Take great care and do this in a moderate pressure in case any accidents happen.
Switching the TV On
1. In Standby mode, press【 】on the remote control or front panel to enter to Power On
mode.
2 The indicator is red when the TV is in Standby mode.
Switching the TV Off
1. Press【POWER】on the remote control or【 】on the front panel to switch off the TV
2. Unplug the power cord from the AC power supply after turning off the AC power to switch
the TV off completely.
Caution: The TV will be shut off automatically when the power trips. Do unplug the
power cord from the AC outlet if so. The last TV mode will appear when
power resumes
Do not turn on/off the TV too often
The TV will enter into Standby mode after 15 minutes when there is no signal input in TV
source; The TV will enter into sleep mode after 30 seconds when there is no stynal input in
PC source.
Installation
General Operation