Pro-Ject Audio Systems CD Box RS - Manual (Page 2)

© Pro-Ject Audio Systems · Pro-Ject CD Box RS · Revision 2014.4.1
2
Dear music lover,
thank you for purchasing a Pro-Ject Audio CD Box RS.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.
! Warning of a hazard for the user, the unit or possible misuse.
Important notice.
Caution! Laser diode, safety instructions
!
This product contains a laser diode of higher class than 1. To ensure continued safety, do not remove any
covers or attempt to gain access to the inside of the product. Refer all servicing to qualified personnel.
AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the
voltage in your area meets the voltage requirements printed on the power supply. The power cord is
used to disconnect the unit from the mains. Make sure that the power cord is easily accessible at all
times. Never handle the device, the power cord/power supply while your hands are wet or damp.
Avoid letting liquids enter the device or the power supply. Never place any item containing liquid,
such as a flower vase on or near the device. Never spill any liquid on the device or the power
supply. Never place any naked flame sources, such as lighted candles on or near the device. The product
shall not be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar
conditions.
Discs to avoid
!
If a disc is cracked, chipped, warped, or otherwise damaged, don't risk to play it. You could end up
damaging the unit. This player is designed for use with fully circular, full size CDs only. Use of shaped
discs is not recommended. The manufacturer and the distributor disclaims all liability arising in
connection with the use of damaged or shaped discs.
Connectors
!
Make all connections whilst the CD player is disconnected from the power supply.
Never use any other power supply than the one supplied with the unit, except of Pro-Ject Power Box.
Connection to an external D/A-converter
Connect one of the digital outputs Out coax, Out opto, Out AES/EBU or i 2 S (Out Sonic/Clock In) to a
matching digital input on the D/A converter or AV processor.
!
Out Sonic (I 2 S) and Clock In can be used with Pro-Ject DAC Box RS and Pre Box RS Digital only.
The cable length for Sonic and Clock connection must not be longer than 29,5 inch (75cm).