Pro-Ject Audio Systems Stream Box DSA - Manual (Page 4)

4
Connection to an external music source unit
The Stream Box DSA provides four connections for external source units, two analog and two digital. connect
the rcA Analog In1 or Analog IN 2 sockets via a rcA cable with the output of your source unit. The digital
inputs S/PDIF and Optical serve for connections with digital outputs of source units via respective coaxial or
optical cables.
Connection to your home network via cable
connect the Ethernet socket with your home network using a rJ45 cable.
Wireless connection to your home network
If a wired network connection isn’t possible or desired, the Stream Box DSA is capable of connecting to the
home network via WlAn. Fasten the WlAn antenna to the connector near the upper left corner on the back
of the unit. The antenna should be angled into upright position or to one side.
USB connections
Here you can connect uSB harddisks or uSB flashdisks. The Stream Box DSA only works with harddisks and
flashdisks that are formatted with FAT 16 or FAT 32. nTFS disks are not supported.
Mains power connection
The unit is supplied with a power supply suitable for your country’s mains supply. check the label before
connecting to ensure compliance with the mains rating in your house. connect the low voltage plug from the
power supply to the Power 24V  socket before connecting the power supply to the mains.
It isn’t possible to disconnect the Stream Box DSA completely from mains power by the power button.
Therefore it consumes a small amount of power even then, when it is switched into stand-by mode. If you are
not going to use the player for an extended period of time, e.g. vacation, we suggest to disconnect it from the
Ac mains. Please make sure that the player is in standby-mode prior to unplugging the power supply from the
Ac mains.
Safety Instructions
Use the Stream Box DSA only with the DC 24V/5A power supply it is delivered with.
AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the
voltage in your area meets the voltage requirements printed on the power supply. The power cord is
used to disconnect the unit from the mains. Make sure that the power cord is easily accessible at all
times. Never handle the device, the power cord/power supply while your hands are wet or damp.
Avoid letting liquids enter the device or the power supply. Never place any item containing liquid,
such as a flower vase on or near the device. Never spill any liquid on the device or the power supply.
Never place any naked flame sources, such as lighted candles on or near the device. The product
shall not be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other
similar conditions.