Pro-Ject Audio Systems USB Box S - Manual (Page 2)

© Pro-Ject Audio Systems · Pro-Ject USB Box S+ · Revision 2014.3.31
2
Dear music lover,
thank you for purchasing a USB Box S+ from Pro-Ject Audio Systems.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.
! Warning of a hazard for the user, the unit or possible misuse.
Important notice.
Safety instructions
!
AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the
voltage in your area meets the voltage requirements printed on the power supply.
The power supply is used to disconnect the unit from the mains. Make sure that the power supply is easily
accessible at all times.
Never handle the device, the power supply while your hands are wet or damp.
Avoid letting liquids enter the device or the power supply. Never place any item containing liquid,
such as a flower vase on or near the device. Never spill any liquid on the device or the power supply.
Never place any naked flame sources, such as lighted candles on or near the device. The product shall not
be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.
Connectors
!
Make all connections, except the connection to the computer, whilst the unit is disconnected from
the power supply. Connect the unit to the mains and switch it on before connecting it to the
computer.
Take care to connect the left and right channels correctly. The right channel is usually marked red,
the left channel black or white.
Never use any other power supply than the one supplied with the unit.
Mains power connection
Connect the low voltage plug from the power supply to the Power 9V DC socket before connecting the power
supply to the mains.
Connection to the amplifier
Connect the Left/Right Out socket to a line input (such as AUX) on your amplifier.
Connecting to a computer
Connect the USB-input to a free USB-socket on your computer and turn it on/make sure it is powered on.
The DAC will be automatically recognised by the computer.
* For Windows
® operating systems a 24Bit/192kHz driver (supplied on CD) has to be installed. Mac OS ®
operating systems support 24Bit/192kHz as a standard.
Please note: Connection should be made to an USB-socket of your computer directly. Connecting to
USB-hubs or switches can cause problems.