Cobra Electronics ESD-9110 - Manual (Page 9)

3
O P E R AT I O N • S E T T I N G S
4
D E T E C T I O N
13 12
VG-2 Alert ® Audio Setting
The ESD-9110 is undetectable by police
VG-2 detection devices, and will alert you
when such a device is in use near your
vehicle. During the alert, the unit continues
to detect other signals. You can choose
whether or not you want your unit to
sound VG-2 alerts.
The factory setting is VG-2 Audio On.
X K K a V S
Signals Detected
The tables on the following pages show
you the types of signals your ESD-9110
will detect, as well as the visual alerts it
provides for each one.
Audio Alerts
A distinctly different alert tone is used for
each type of signal detected (including
separate tones for each laser signal). For
X, K, and Ka band radar signals, the tones
will repeat faster as you approach the
signal source. The repeat rate of the tones
gives you useful information about the
signal detected. (See Responding to Alerts,
page 16.)
Visual Display
An indication of the type of signal
detected will appear in the UltraBright™
Data Display. During X, K and Ka alerts,
a number will also appear, indicating
the strength of the signal detected.
(1 = weakest, 5 = strongest)
During laser alerts the letter ”L“ will appear,
instead of the signal strength indication.
During VG-2 Alert ® the letter ”V“ will appear.
During Safety Alert ® and Strobe Alert™
the letter “S” will appear.
X K Ka V S
X K Ka V S
X K Ka V S
X K Ka V S
X K Ka V S
X K K a V S
DIM button
Press and hold for 2 seconds
To turn off
VG-2
audio alert
To turn on
VG-2
audio alert
Procedure
While no signal is
being detected,
press and hold
the DIM button
for two seconds.
While no signal is
being detected, press
and hold the DIM
button for two
seconds again.
Tone
1 beep
2 beeps
Visual Display
V
will blink
once in
the display
V
will blink
twice in
the display.