Pro-Ject Audio Systems Pro-Ject Signature 12 - Manual (Page 3)

Set-up
Read thoroughly the manual and follow all instructions after unpacking the turntable.
Make the turntable assembly of distributed components in the package.
1. Installation of adjustable feet (9)
The feet are disassembled for transport and stored in the package of platter.
Screw the feet into the thread inserts of the turntable plinth.
2. Platter assembly
Before platter (1) assembly, unscrew three transport screws.
Remove protective covers from shaft and platter bearing.
Check for adequate lubrication of the shaft (2).
If necessary, lubricate with grease in the attached accessories.
WARNING:
The platter is floating on magnets.
When putting on the shaft, take care not to damage the magnet.