Hese, Nstructions – Cortelco Patriot II 2194**V0E27S User Manual

Page 4

Advertising
background image

11.Do not use a telephone in the vicinity

of a gas leak to report the leak, or otherwise.

12.Unplug the telephone from the wall

outlet and refer servicing to qualified service person

nel under the following conditions:

•When the line cord is frayed or plugs damaged.

•If liquid has been spilled into the telephone.

•If the telephone has been exposed to rain or water.

•If the telephone does not operate properly by followi

ng the operating instructions.

•If the telephone has been dropped or the housing

damaged.

•If the telephone exhibits distinct change in

performance.

S

AVE

T

HESE

I

NSTRUCTIONS

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not

expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the

limits for a CLASS B digital device,pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

-

Reorient or relocate the receiving antenna.

-

Increase the separation between the equipment and

receiver.

-

Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

-

Consult the dealer or an experienced radio TV

technician for help.

4

Advertising