PulseTech HD-BT12 Bench Top Charger (746X850) - Manual (Page 3)

- 1 -
IMPORTANT SAFETY INSTRUCTIONS
1. SAVE THESE INSTRUCTIONS – This manual contains important safety
and operating instructions for your HD BENCH TOP battery charger.
2. Use of an attachment not recommended or sold by PulseTech Products
may result in a risk of fire, electric shock, or injury to persons.
3. To reduce risk of damage to electric plug and cord, pull by plug rather
than cord when disconnecting charger.
4. An extension cord should not be used unless absolutely necessary. Use
of improper extension cord could result in a risk of fire and electric shock.
If extension cord must be used, make sure:
a) That pins on plug of extension cord are the same number, size
and shape as those of plug on charger;
b) That extension cord is properly wired and in good electrical
condition; and
c) That wire size is large enough for ac ampere rating of the charger
as specified:
Length of cord (ft): 25 50 100
AWG size of cord: 16 12 10
5. Do not operate charger with damaged cord or plug – replace the cord
or plug immediately.
6. Do not operate charger if it has received a sharp blow, been dropped,
or otherwise damaged in any way; take it to a qualified serviceman.
7. Do not disassemble charger; take it to a qualified serviceman when
service or repair is required. Incorrect reassembly may result in a risk of
electric shock or fire.
8. To reduce risk of electric shock, unplug charger from outlet before
attempting any maintenance or cleaning. Turning off controls will not
reduce this risk.