Rally Armor 11-14 Subaru WRX Hatchback User Manual
Page 2
REAR MUD FLAPS
- PLEASE READ THE INSTRUCTIONS THOROUGHLY
Figure D. -Remove rear tire. Carefully remove and retain factory fastener. You will be re-using this piece.
Place two flat U-Clips over the two outer mounting holes in the bumper.
Figure E. - Place mud flap against vehicle in a manner where it matches the curvature of the wheel well and liner.
Re-install factory fastener through mud flap into original mounting point. Thread a screw with washer through the two outer mud
flap mounting points. Adjust mud flap to ensure it is perpendicular to the ground. Tighten only until snug. Do not over-tighten.
Figure F. – Using a Philips driver, install two screws (no washers) through the remaining mounting holes.
The screws will self-tap and go into the plastic liner.