Rally Armor 10-14 Subaru Outback - Manual (Page 2)

IMF14/IMF16 Version 1.1 Release Date 3.24.2010
2
Front Mud Flap Installation
• (Figure A) Park vehicle on an even surface. Turn the steering wheel towards the side you are working on to gain access to the wheel
well area. Remove the four OEM fender liner retainer clips.
• (Figure B) Pull liner away to gain access to inner fender and place three clips over each of the mounting points as shown. Replace
liner.
• (Figure C) Position the front mud flap with logo facing the rear of the vehicle. Using a long screw (1.5SS) and a large washer (Wash),
loosely bolt the mud flap to each mounting point. Do not tighten mounting points. Adjust mud flap before tightening down for proper
alignment.
Align outer edge of the flap by incrementally adjusting the
side to side, lower/upper portion of the flap and walking
away from the vehicle until the flap is perpendicular to even
ground. Tighten all mounting screws only until snug against
washer. Do not over tighten.