Option programming – Crimestopper Security Products RS-850 User Manual

Page 12

Advertising
background image

OPTION PROGRAMMING

IMPROVED: Now you can program multiple options in one session if you start with the lowest option and continue on to
higher options [if needed] without repeating the steps #1-3. For example, you can change Option #2 to “ON” by pressing
the lock button, then you can continue pressing the program button to get to a high number option and change it as well
without having to repeat Steps 1-5. You can only go from low to higher options numbers in one session.

Option Programming:
1. Open hood (Ground the Gray wire if no hood pin is installed).
2. Turn Key to the ON position
3. Press program button 5 times, after a few seconds the unit will flash the lights 5 times.
4. Push the valet/program button [again] the number of times that corresponds to the option number desired. You

should get a light flash after each button press. If the system did not flash the lights, then it did not register your
press.

5. When you reach the desired programming level, Press button #1(Lock) or #2 (Start) to change the option. See

the chart below for option values and descriptions.

6. Turn Ignition OFF, Close hood and check for changed features.

OPTIONS

CHART *

=

DEFAULT

Option

#

Option Description

Option Values

Button #1

LOCK

Button #

START

1

NOT

USED

2

Door Lock Pulse Time

0.75 Sec. (Standard) OR
3.0 Sec. (European Vacuum)

3 Sec.

0.75 Sec.*

3

Double Unlock Pulse

ON or OFF

ON

OFF*

4

Engine Monitoring

Tach (Engine RPM) or
Tachless Mode

Learn Tach

Tachless*

5

Remote Start Engine Run
Time

Button #1 = 48 Min.
Button #2 = 24 Min.

36 Min.

24 Min*.

6

Smart Tachless Voltage
Adjust (80-100%) Only when
Option #4 is set to Tachless

Button #1 = Decrease by 1%
Button #2 = Increase by 1%

-1%

+1%

7

Option reset

Button #2

Reset to

Default


12



Advertising