Samson 12-STRAND Class II End-for-End Splice Modified for Dirty, Used Rope - Manual (Page 3)

PAGE 3 OF 4
SamsonRope.com | Email [email protected] | Tel +1.360.384.4669
12-Strand Class II End-for-End Splice Modified for Dirty, Used Rope
S A M S O N S P L I C I N G I N S T R U C T I O N S
Pull both tails to tighten crossover.
Next, smooth braid in both directions
away from the crossover, stroking rope
firmly. Tails should bury inside cover.
S m o ot h i n g o U t S p l i C e
Attach tapered tail of Rope B to fid.
Insert the fid into Rope A at Mark 2,
approximately the diameter of the line
away from insertion point of Rope A
into Rope B. Bring fid and tail out at
Mark 3 of Rope A. Following same
procedures as Step 8A bury Rope
B up to its own Mark 2. Leave tail
sticking out.
F i n i S h B U Ry i n g
9
step
mark 3
Rope A
mark 2
mark 2
Rope B
mark 3
Rope A
Rope B
Tapered tail
fid
Rope B
Rope A
Tapered tail
Pull
Tail B
Rope A Smooth Smooth
Rope B crossover
Pull
Tail A
Finished splice
Buried tails
Attach tail of Rope A to fid.
Insert fid at Mark 2 of Rope B,
bring out past Mark 3, then
remove fid. When feeding
the fid through with the tail
attached, do not hold on to
the fid and try to milk the
slack back. Doing this will
cause the tapered end to
disconnect from the fid.
Hold on to the section
of the tapered end
right above the fid
to avoid this.
B U Ry i n g R o p e a i n t o R o p e B
8 A
Tie off the tail of Rope A to a
stationary object, then use both
hands and weight of your body to
smooth Rope B toward Rope A to
bury Rope A up to its own Mark 2.
Leave tail sticking out.
mark 1
Rope A Rope B
mark 2
mark 2
mark 3
Rope B
fid
Grip both the
tail and fid ends
where they stop
in the rope
Milk toward gripping hand
Ta
pered
tail
8
step
10
step