Samson MISCELLANEOUS Smooth Ice/Flavored Ice Cover Installation - Manual (Page 3)

© 2012 Samson Rope Technologies, Inc. All rights reserved. S/WD #108294 7/2012
PAGE 3 OF 3
SamsonRope.com | Email [email protected] | Tel +1.360.384.4669
Lock Stitching Procedure Whipping Method i
S a M S O n S P L i C i n g i n S T r U C T i O n S
S T E p 1
Form loop along the rope with whipping
twine and wrap end around the back.
S T E p 3
Cut both ends close to whipping.
S T E p 2
Continue wrapping at least 1 rope diameter in length.
Finish with end through loop then pull
opposite end to bury loop under whipping
Pull to bury
Choosing twines for whipping:
In general, braided nylon twine is preferred for whipping. Polyester twines, or twisted twines in either
polyester or nylon, can also be used.
For double braids the twine used should be approximately twice the diameter of the strands in the cover.
Whip or seize the end of the spliced area with whipping twine for extra security and a professional touch.
Keeping tension on rope while wrapping results in tighter whipping.
Whipping Finished Splice Method i
S T E p 4
After completing Step 3, rotate spliced part of rope 90° and reinsert
end A into spliced area in the same fashion as in Steps 1, 2 and 3.
The splice will now be stitched on 2 planes perpendicular to each
other. Make sure you do not pull the stitching too tight.
S T E p 5
After stitching at least 3 complete stitches as in Step 3, extract both
ends of the twine together through the same opening in the braid.
Tie them together with a square knot and reinsert back into braid.
For double braids, re-insert the knot between the cover and core.
B
A
A
B
1 2 3
A
B
1 2 3
A
B
S T E p 1
Pass stitching twine through
spliced area near throat of
eye as shown.
S T E p 2
Reinsert twine through the
rope. The twine should
cover 2 strands from the
exit point. Pull the twine
snug, but not tight.
S T E p 3
Continue to reinsert as
shown until you have at
least 3 complete stitches
on each side of the rope.
Each stitch should cross
over 2 strands in the rope.
DOCUMENT ICE_Cover Install_AUG2012.pdf