Scilogex MS-Pro - Manual (Page 10)

8
MS-(H)-Pro Digital（Hotplate）Magnetic Stirrer
Items Default settings
Operating mode A
Setting temperature (°C ) 25
SAFE (℃ ) 350
Setting rotary speed (rpm) 100
Residual heat warning On
Stirring bar breakaway monitoring OFF
Table 4
6.3 Resetting parameters to factory settings
Reset the parameters to the default settings, as follows:
• Turn off by the power switch‘O/I’to‘O’
• Have the keys “Set” and “Mode” pressed down at
the same time and switch on the main O/I switch. Release
buttons after 5 seconds.
• The unit is now set to the factory default settings.
7 Operating modes
7.1 Operation modes of MS-H-Pro:
Operation mode A
●
MS-H-Pro has heating and stirring functions.
●
Users can control on the front panel or by remote PC.
●
Residual temperature warning, safe temperature limit and
stirring bar breakaway monitoring can be set in this mode.
Operation mode B
●
MS-H-Pro has heating and stirring functions.
●
Users can control on the front panel or by remote PC.
●
Residual temperature warning, safe temperature limit and
stirring bar breakaway monitoring can be set in this mode.
Operation mode C
●
MS-H-Pro maintains the state of the heating and stirring
functions before the last switching off (mains OFF), as well
as the data set last can be changed.
●
Remote control can be used without supporting external
temperature sensors.
●
Residual temperature warning, safe temperature limit
and stirring bar breakaway monitoring can’t be set in this
mode.
7.2 Operation modes of MS-Pro:
Operation mode A
●
MS- Pro has heating and stirring functions.
●
Users can control on the front panel or by remote PC.
●
Stirring bar breakaway monitoring can be set in this
mode.