Sonex Material Planning Guide (for Scratch Building) - Manual (Page 2)

© 2012 Sonex Aircraft LLC. All
Rights Reserved. The information
disclosed herein is the property of
the originator who reserves all pat-
ent, design, proprietary, manufac-
turing, use and sales rights thereto,
except for the rights expressly
granted to others. This document
shall not be reproduced nor shall
the information contained within
be used by or disclosed to others
except as expressly authorized by
the originator.
511 Aviation Road
Oshkosh, WI 54903
Phone (920) 231-8297
fax (920) 426-8333
email:[email protected]
www.sonexaircraft.com
Sonex Aircraft,
LLC
Sheet aluminum layout...
The following illustrations depict a material-ef-
ficient pattern for cutting the parts out of the alu-
minum sheets. The bold outlines filled with gray
represent the individual sheets of aluminum. The
size of each sheet of aluminum is identified above
each illustration. The thin outlines filled with
white represent the individual parts of the Sonex.
The parts are identified in one of two ways: by
Sonex part number or by description. Gray areas
represent extra material which can be used for the
miscellaneous small parts not specifically illustrat-
ed. It is suggested that the large parts be cut from
each sheet before the small parts are removed.
Please note that the .060 and .090 6061-T6 sheets,
as well as the .016 stainless steel, are not illus-
trated. The few parts needed from these materials
can be easily produced from the blank sizes given
in the material list.
.025 6061-T6 aluminum sheet, 4’ x 12’
.025 6061-T6 aluminum sheet, 4’ x 12’
SNX-B07.9
Material
Planning
Guide
Page 2 of 6
rev. n/c
MATERIAL PLANNING GUIDE
(cont.)
.025 6061-T6 aluminum sheet, 4’ x 12’